Multi-Tech Systems MT5634ZPX-PCI-V92 - Manual (Page 52)

5 Remote Configuration
47
MultiModemZPX User Guide
4. The new password is saved automatically. You can now either enter more AT
commands or exit the data communications program. The next time you wish to
set up the modem, you must use the new password.
To Change the Remote Escape Character
To further improve security, you can change a remote modem’s remote configuration
escape character either locally or remotely. The remote configuration escape charac-
ter is stored in register S9. The factory default is 37, which is the ASCII code for the
percent character (%). Setting S9 to 0 (zero) disables remote configuration entirely.
CAUTION: If you do this remotely, you won’t be able to change it back remotely.
1. Establish a remote configuration link with the remote modem as described in
“Basic Procedure.”
2. Type ATS9=n, where n is the ASCII code for the new remote configuration es-
cape character, and then press E NTER .
3. Save the new value by typing AT&W and pressing E NTER .
4. Type ATO and press E NTER to exit remote configuration.