Meco Bonza Deluxe Series - Manual (Page 12)

1/4” x 1” BOLT - WOOD LEG
1/4” x 1 3/8” BOLT - METAL LEG
STEP 4-BOTTOM SHELF/LEG & CASTER ASSEMBLY
•Place Leg/Side Table assemblies opposite each other as shown with the velcro patches on same side.
•Place Bottom Shelf inside of Wheel Leg assembly and align large axle holes. Insert Axle through axle
holes in both sides of legs and shelf. The Axle will support this end of Bottom Shelf while securing
Fixed Leg assembly.
•Position Caster Assembly with caster wheels up and side of bracket against Bottom Shelf. Align the
Caster Bracket, Bottom Shelf, and Fixed Leg holes and fasten using 1/4” X 2” Bolts. Attach Wheel
Legs to Bottom Shelf using 1/4” x 1” Bolts. Metal Tubing Legs will use 1/4” x 1 3/8” Bolts. Tighten
Wheel Leg bolts before proceeding.
•For Bonza Deluxe, align the Bottom Shelf and Leg holes and fasten using 1/4” x 1 3/8” bolts. At-
tach Bonza Deluxe Wheel Legs the same way. Thread casters into end of leg.
• Bonza Deluxe - Important Note: When assembling Bottom Shelf on metal legs, the Axle hole in the
Bottom Shelf is not used(See Illustration below).
12
BOTTOM SHELF
1/4” x 1” BOLT - WOOD LEG
1/4” x 1 3/8” BOLT - METAL
VELCRO
PATCHES
ON THIS
SIDE
AXLE
WHEEL LEG
ASSEMBLY
FIXED LEG
ASSEMBLY
CASTER
ASSEMBLY
1/4” x 2” BOLT - WOO
(ITEM 16 OR 17) AXLE
(ITEM 15) BOTTOM SHELF
(ITEM 18, 19, 20)
CASTER ASSEMBLY
(ITEM 8) 4 pcs
1/4” x 1” BOLT
(ITEM 21) 1/4” X 2” BOLT 4 pcs
(ITEM 9) 8 pcs
1/4” X 1 3/8” BOLT
(DELUXE MODELS)
TOOLS:
1/4” X 1 3/8” BOLT - METAL
DELUXE
METAL LEG
DELUXE
CASTER
AXLE
HOLE