Meco Bonza Deluxe Series - Manual (Page 9)

STEP 1- WHEEL LEG/ SIDE TABLE ASSEMBLY TOOLS:
•Note: There are two side table designs used depending on the model: Left and Right Teardrop Side Tables (Item 1 & 2),
or Deluxe Side Tables (Item 3).
•Lay Left Side Table (depending on your model you have either 2 or 4) upside down on flat surface as shown. Locate the
two Wheel Legs which are the shorter legs with a large axle hole at one end.
•On models with wooden legs, place Rear Wheel Leg so four large recessed holes face away from Side Table
(Fig. A) and two threaded holes in edge of leg point outward. (Fig. B)
• Insert four 1/4” x 1” (1/4” x 1 3/8” for
Metal legs) Bolts through the leg into the
threaded holes of Side Table. (Fig. A) Do not
tighten bolts completely.
• Attach Front Wheel Leg to Left Side Table
in the same way. On models with wooden
legs make sure the two threaded holes on
the edge of each leg face outward. Make
sure the three velcro patches face inside on
all models.
FIG. B
THREADED HOLES IN LEGS
(Deluxe Models with Metal legs do
not have these threaded holes and
can be oriented either way.)
AXLE HOLES
(WHEEL LEGS)
FRONT WHEEL
LEG - THREE
VELCRO
PATCHES FACE
INSIDE
SIDE TABLE
(TEARDROP
TABLE
SHOWN)
REAR WHEEL LEG
BONZA - WOOD
BONZA DELUXE - METAL
FIG. A
FOUR LARGE
RECESSED HOLES
(Wooden Legs Only)
1/4” x 1” BOLT
9
(ITEM 9) ACTUAL SIZE
1/4” x 1” BOLT 8 pcs
(1/4” X 1 3/8” Deluxe Models)
(ITEM 1 or 3) SIDE TABLE
(ITEM 7) FRONT WHEEL LEG - METAL TUBING
(ITEM 6) REAR WHEEL LEG - METAL TUBING
(ITEM 10) ACTUAL SIZE
1/4” X 1 3/8” BOLT 8pcs
OR
(ITEM 5) FRONT WHEEL LEG - WOOD
(ITEM 4) REAR WHEEL LEG - WOOD
OR