Meco Bonza Deluxe Series - Manual (Page 17)

. •Fit venturi end of Burner through hole in the inside firewall (behind control panel) and onto Gas
Control Valve Nozzle (Fig. E & Fig. F). Be careful not to bend or force gas collector plates.
•Place other end of burner on lower
shoulder of rear firewall so Burner
Peg rests in Burner Locator Hole as
shown (Fig. G).
•Using Pliers, insert Cotter Pin
through hole in Burner Peg to
secure. This is easier done
from backside of grill looking up
underneath rear firewall.
•Repeat above steps for remaining
burners .
Holes in
Front firewall.
Gas Nozzle
Control Valve
Manual Lighting
Holes
Top plate
of gas collector.
Gas Collector and
Electrode
Venturi end of
Burner inserted
over gas nozzle.
FIG. F
FIG. E
REFERENCE: ELECTRODE GAP
Adjust Tab until spark is visible.
ELECTRODE
3/16” Approximate gap
TAB-GAS COLLECTOR
FIG. G
BURNER BURNER PEG
BURNER
LOCATOR HOLE
IN LOWER
SHOULDER
COTTER PIN
Install from
underneath
Backside of grill.
17