Meco Bonza Deluxe Series - Manual (Page 31)

Bottom Panel
Drip Pan
31
6. Close the hood and remove the drip pan and bottom
panel to dispose of ashes. The bottom panel can be
removed by first removing the screw on each side of
the grill. For easier cleaning of charcoal ashes the bot-
tom panel can be lined with aluminum foil. Make sure
all openings are left unobstructed and cut a hole for the
grease to drip into the grease pan.
7. Reinstall drip pan and bottom panel.
8. Reinstall the burners and lower the louvers into position.
Make sure the left louver rests on the right louver when
rotated into position.
9. Push, then pull the louver adjusting knob to ensure the
louvers function correctly.
10. Install cooking grids.
11. Position louvers in either gas or charcoal mode to
prepare for next cooking session.
Cleaning instructions for Charcoal and
Wood chunk ash(Continued)
· Follow all instructions and warnings listed on the
polyurethane container.
· Always use a brush to apply the polyurethane, do not
use a spray can.
· Do not apply polyurethane to the metal grill body.
· Using the Grill Storage Cover (50) will help maintain
the appearance of your grill and protect the finish.
In addition to the above Care and Maintenance Instruction,
periodically check and tighten all nuts, bolts, and screws.
Preventive Maintenance
· Always turn off the LP gas cylinder at the LP
cylinder valve when not in use. Allow grill to cool
before handling parts or cleaning.
· Do not use aerosols or store flammable liquids or
materials near this gas grill.
· Never apply polyurethane to the wood cart while
grill is in use or hot. Allow polyurethane to
completely dry before further use.
Caring for the Wood Cart
· Never store an LP gas cylinder indoors (empty or
filled). If storing the gas grill indoors,
disconnect the LP gas cylinder and store it outdoors
out of the reach of children.
· Never leave an LP gas cylinder inside a
vehicle which may become overheated by the sun.
· Never store a spare or disconnected LP gas
cylinder under or near the LP gas grill.
· Always turn off the gas cylinder when not in use.
Allow grill to cool before handling parts or
cleaning.
· Even though your LP gas cylinder may appear to
be empty, gas may still be present and the cylinder
should be transported and stored accordingly.
· Store your LP gas grill in a cool dry place .
· Disconnect LP gas cylinder from grill and store outside,
in a dry, well-ventilated area, away from any sources of
heat or ignition. Re-cap LP cylinder valve with the Safety
Cap.
· Remove burners and wrap with aluminum foil to prevent
insects from entering the burner holes. Store wrapped
burners on top of the cooking grids.
· Before next use, remove aluminum foil and reinstall
burners and grids according to Steps 8 and 10 of
Assembly Instructions.
· Check your LP gas grill for gas leaks, deterioration,
proper assembly, and burner obstructions before using the
Storage
Your Cart is manufactured using a hardwood ideally suited
to outdoor use. To maintain its condition and appearance,
annual application of polyurethane is recommended.