Macsense Connectivity MIH-120 User Manual
Page 11
2.
Plug one RJ-45 connector (of a standard twisted-pair Ethernet
cable) to the XRouter’s No. 4 LAN port.
3.
Plug the other end of this Ethernet cable into an available port
on the network hub.
(NOTE: Multiple network hubs can be connected to the
XRouter’s LAN ports No.1-3 if these hubs are equipped with
uplink ports. By daisy-chaining a series of hubs, you can
connect up to 252 users to the XRouter.)
Connecting the Power Supply
To provide your XRouter with power:
1.
Plug the power adapter of the XRouter into an AC power
outlet.
2.
Plug the other end of the power adapter cable into the power
receptacle on the rear panel of the unit.
3.
The Power LED on the XRouter’s front panel should be lit
immediately.
7
LAN
WAN
Reset
Cable Or DSL Modem
Ethernet Cables
PC
Mac
Hub
Figure 1.2 - Connect an Existing LAN