Macsense Connectivity MIH-120 - Manual (Page 25)

TROUBLESHOOTING
This chapter provides solutions to problems that may occur during
installation and operation of the XRouter MIH-120.
1. The Link LED is off.
• Check that all connectors are firmly plugged-in.
• Check the power adapter making sure it is plugged into an
electrical outlet.
2. The collision LED is always lit.
• Make sure the 10BASE-T cable has not exceeded the
maximum 100-meter length limit.
• Check all connectors to make sure they are firmly
plugged into the appropriate ports.
• Use category 5 cables as this grade of cable will give you
the highest quality connection to the XRouter.
• Check the RJ-45 connectors at both ends of the cable to
make sure there is no faulty wiring.
5. Can't connect to MIH-120 XRouter via Web browser.
• Verify that the IP address 192.168.1.1 has been correctly
entered in the URL field.
• Check the network cable connection and LAN LED indicator
on the XRouter.
• Check out the TCP/IP setup on your client. Type "winipcfg"
on DOS prompt under Windows 95 or open the TCP/IP con-
trol panel on the Mac OS platform. The client should get an
IP address of 192.168.1.x (where "x" is from 1 to 252.)
Troubleshooting
25