Minicom Advanced Systems Minicom Smart 116 IP - Manual (Page 39)

USER GUIDE
38
2. Click . A further warning appears, see below.
Figure 36 Warning
3. Click OK, the factory defaults are restored. When the process finishes Figure 37
appears.
Figure 37 Reboot
4. Click Reboot to restart the unit.
23.3 Restoring the device firmware
Contact Minicom Technical Support [email protected] , to receive the
Upgrade firmware required to restore the device firmware. Save the Upgrade
firmware on the hard disk of a computer connected to the network.
To restore the device firmware:
1. From the Safe mode menu choose Firmware Upgrade.
2. Locate the Upgrade firmware and click Install, then click Start Upgrade. The
firmware upgrades. When the process finishes Figure 38 appears.
Figure 38 Reboot
3. Click Reboot to restart the unit.