IBM Partner Pavilion iLV300 - Manual (Page 16)

To control your computer mouse using the projector remote control, connect the
projector to the computer with a USB cable (not included), as shown in Figure 2-7.
USB drivers must be installed to use the USB feature. For more information, see
“Using the projector with Windows 98”.
Using the projector with Windows 98
The first time you connect a computer running Windows 98 to the projector, the
computer recognizes the projector as “new hardware” and the Add New Hardware
Wizard screen appears. To use the Wizard to load the correct driver (which was
installed with your Windows operating system), complete the following procedure:
Note: If you are running Windows 2000 or Windows ME, skip these steps and
continue with “Adjusting the image” on page 2-5. If you are running
Windows 2000, Windows ME, and Windows XP and you connected the USB
cable, the USB drivers are automatically installed.
1. After the Add New Hardware Wizard screen appears, click Next to begin
searching for the driver.
2. Select Search for the best driver.
3. Click Next.
4. Uncheck any checked boxes, then click Next. Windows automatically locates
the driver. If this driver has been removed, reload the driver using your
Windows operating system CD.
5. When Windows finds the driver, click Next to install the driver.
Figure 2-6. Connecting the monitor cables
Figure 2-7. Connecting the projector and computer with a USB connector
2-4 IBM iLV300 Value Data/Video Projector: User’s Guide