IBM Partner Pavilion iLV300 - Manual (Page 33)

v Turn on power saving features.
v Specify blank screen colors and start up logos.
v Specify the language viewed on the menus.
v Save settings for the active source as a preset.
Shutting down the projector
The projector automatically displays a black screen after no active source is
detected for 30 minutes. This black screen helps preserve the life of the projector.
The image returns when an active source is detected or a remote or keypad button
is pressed.
Screen Save
You can make the black screen appear after a preset number of minutes by turning
on the Screen Save feature in the Settings>System menu. See “Settings menu” on
page 5-5.
Power Save
The projector also has a Power Save feature that automatically turns the lamp off
after no active sources are detected and no user interaction with the projector is
performed for 20 minutes. By default, this feature is off. See “Settings menu” on
page 5-5.
Turning off the projector
You can turn the projector off simply by toggling the power switch to the off
position.
You can also press the remote’s Power button to place the projector in the Off state
while it is running. When the Power button is pressed twice (once to start the
power-down process and a second time to verify that you want to power the
projector off), the lamp turns off and the LED blinks green for one minute while
the fans continue to run to cool the lamp. While the LED is blinking green, the
projector does not accept any keypad and remote control input.
When the lamp has cooled, the LED lights solid green and the fans slow down to
minimal speed. To turn off the projector, toggle the power switch to the off
position.
Note: Once the projector has been toggled off, you must wait for one minute
before turning the projector on again. This allows the lamp to properly cool.
However, if the remote was used to power the projector to the Off state you
do not need to wait one minute to turn it on again.
Chapter 4. Using the projector features 4-7