IBM Partner Pavilion iLV300 - Manual (Page 35)

Chapter 5. Using the menus
To open the menus, press the Menu button on the keypad or remote. (The menus
automatically close after 60 seconds if no buttons are pressed.) The Main menu
appears, as shown in Figure 5-1.
Use the arrow buttons to move up and down to highlight the desired submenu,
then press the Select button.
To change a menu setting, highlight it, press Select, then use the up and down
arrow buttons to adjust the value, select an option using radio buttons, or turn the
feature on or off using check boxes. Press Select to confirm your changes. Use the
arrows to navigate to another setting. When your adjustments are complete,
navigate to Exit, then press Select to go to the previous menu; press the Menu
button at any time to close the menus.
Dots appears before the menu name. The number of dots indicate menu level,
ranging from one (the Main menu) to four (the most nested menus).
The menus are grouped by usage:
v The Picture menu provides image adjustments.
v The Settings menu provides set-up type adjustments that are not changed often.
v The About menu provides a read-only display of information about the projector
and source.
Certain menu items may not be visible or may be grayed depending upon a
particular source being connected. For example, Sharpness is only available for
video sources and is not visible when a computer source is active. Menu options
are grayed out only if the source if selected but no signal is present. For example,
if the projector is set to a video source but the source, such as a DVD player, is
turned off video menu options are grayed out.
Figure 5-1. Main menu
Figure 5-2. Navigation buttons
© Copyright IBM Corp. 2003 5-1