IBM Partner Pavilion iLV300 - Manual (Page 48)

Table B-1. Troubleshooting (continued)
Problem Solution
The image does not fit in the 4:3
or 16:9 screen. Change the aspect ratio to 4:3 or 16:9 in the
Picture>Aspect ratio menu.
The image is upside down. Turn off ″ceiling″ in Settings>System menu.
The image is reversed to the left
or right. Turn off the rear in Settings>System menu.
The projected colors do not match
the source. Adjust the color, tint, color temperatures, brightness,
and contrast in the menus.
The lamp will not turn on and
the red LED is blinking.
v Make sure the vents are not blocked.
v Turn off the projector and allow it to cool for a
minute.
v Check the lamp hours, by selecting Main>About. If
the lamp hours are greater than 3,000, then the lamp
must be replaced. For instructions on replacing the
lamp, see “Replacing the projection lamp” on
page A-1.
The ″Change lamp″ message
appears at startup.
Check the lamp hours, by selecting Main>About. If the
lamp hours are greater than 3,000, then the lamp must
be replaced. For instructions on replacing the lamp, see
“Replacing the projection lamp” on page A-1.
Projector LEDs
The LED on top of the projector indicates the state of the projector and can help
you troubleshoot.
Table B-2. Projector LEDs
LED color Meaning
solid green The power switch has been toggled on and
the software has initialized or the projector
has been powered off via the remote.
blinking green The power switch has been toggled on and
the software is initializing, or the projector is
powering down and the fans are running to
cool the lamp.
blinking red A fan or lamp failure has occurred. Make
sure the vents are not blocked. Turn off the
projector and wait one minute, then turn the
projector on again. If the projector has been
working for 3,000 hours or more, replace the
lamp and reset the lamp timer. For
instructions on replacing the lamp, see
“Replacing the projection lamp” on
page A-1. Contact IBM technical support if
the problem persists.
solid red An unidentifiable error. Please contact IBM
technical support.
If the projector is not functioning properly and the LED is blinking red, see
Table B-3 on page B-3 to determine a possible cause. There are two-second pauses
between the blinking cycles. For more details on LED projector errors, contact your
B-2 IBM iLV300 Value Data/Video Projector: User’s Guide