IBM PS1500 - Manual (Page 86)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4•22 User Guide
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
CHANGE THE NAME OF A PRESET
1. Press PRESET. in the EDIT section.
2. Hold PAGE+/BANK+ pressed to scroll to the last
page (Page 9) to open the “Preset name” win-
dow.
The current Preset name is shown at the “Old
name” position.
The “NewName” position will be active, ready
to accept your character insertions.
Store Preset
PRESET
1
2
9/9 PRESET:GrandP [OverWrite]
Old name=GrandP -----> New name=
PAGE+ / BANK+
PAGE– / BANK–
3
4
5 STORE
PRESET
ENTER ESCAPE
ENTER ESCAPE
3. Change the Preset name using the keys of the
keyboard.
In Name Write mode, the keyboard trans-
forms into a source of alphanumeric data.
Each note corresponds to a letter, number or
symbol.
Write in a new name by striking correspond-
ing keys of the keyboard. Up to 6 characters
can be used to write a name.
How the keys are used for writing in data is
explained in the section entitled “Data entry”
of Chapter 3 (Basic Concepts - page 3-15).
4. Press ESCAPE to close the window.
5. Press STORE PRESET followed by ENTER to save
the Preset name.