Intellinet Network Solutions UNC-W10 - Manual (Page 20)

WIRELESS NETWORK IP CAMERA User’s Guide
Assigning IP Address
Follow these steps to assign an IP address using Hyper Terminal
1. Execute “Hyper Terminal” on your PC
2. Connect RS232 Cable to the serial port of PC that you have selected in Chapter 4.3.1 -
Configuring Hyper Terminal and the Wireless Network IP Camera serial port while Hyper
Terminal is executed.
3. Supply power to the Wireless Network IP Camera.
4. A count down will start with the message “Press any key to stop auto-boot.”
5. Press any key and then “Boot” Prompt shall appear as below.
6. You can see Network Configuration while [Boot] Prompt is running by pressing ‘p’ key again.
19