Intellinet Network Solutions UNC-W10 - Manual (Page 46)

WIRELESS NETWORK IP CAMERA User’s Guide
② Motion Detection from……
This is to detect motion from camera by S/W data comparison.
When you select “Motion detection”, the Wireless Network IP Camera detects a motion
triggered by camera lens. To detect motion the camera compares a previous image from
present
image. When the motion is detected, the camera recognizes the data changing through
comparing the previous image data with present one.
③ Periodically…..
The Wireless Network IP Camera itself is to be triggered automatically by setting.
You may set the periodical event time for certain hour.
④ Motion detection sensitivity
This is to configure the level of motion detection sensitivity.
The level is composed of 9 levels from 0 to 9.
As the level is higher, the sensitivity is much higher
45
NOTE
In a dark place without light, it may never detect the motion because its image wouldn’t be
changed at all.
CAUTION
Do not use motion detection function for security purpose because Motion detection function is
only developed to use for monitoring purpose.
When you want to use it on the purpose of security, you should use certain sensor such as infrared,
motion sensor according to your purpose.
NOTE
In case of level 9 for sensitivity, the camera may detect a tiny motion even a light changes, so
the event can be trigger so often. In case of level 1 for sensitivity, the camera may not detect a
tiny motion, though it can be missed some little motion.
It is strongly recommended to configure it as the level of 3 ~6 for sensitivity.