Intellinet Network Solutions UNC-W10 - Manual (Page 21)

WIRELESS NETWORK IP CAMERA User’s Guide
20
Here, inet on ethernet (e), host inet (h) and gateway inet (g) values are network configuration
values. You should change these values in most case. If you don’t know what value you should
assign, refer to the network administrator.
Inet on ethernet (e) is IP address and subnet mask address of Wireless Network IP Camera. IP
address and subnet mask addresses are separated by colon (:). For example, IP address is
represented by decimal numbers delimited by dot (.) like ‘192.168.1.27’. Hexadecimal numbers
like ‘ffffff00’ in the case of ‘255.255.255.0’ represents subnet mask address. Note that the numbers
of subnet mask value are not delimited by dot. See the example in the above picture.
Host inet (h) is the address to which Wireless Network IP Camera tries to connect to upgrade its
firmware program in flash memory. Wireless Network IP Camera first search this host on the
network on booting sequence. For more information on Wireless Network IP Camera upgrade, refer
to “E. Updating Wireless Network IP Camera’s Newly upgraded Program”.
Gateway inet (g) is the gateway address of Network Camera