Intellinet Network Solutions UNC-W10 - Manual (Page 60)

WIRELESS NETWORK IP CAMERA User’s Guide
A series broad vertical
white line appears
across the image.
The CMOS sensor
becomes overloaded
when the light is too
bright. This can happen
e.g. with sun light
reflexes. Direct exposure to extreme sunlight or halogen light
may cause serious damage to the CMOS sensor.
Reposition your Wireless Network IP Camera into a
more shaded location immediately.
Note: damage caused to Wireless Network IP
Camera through over exposure to direct sunlight or
halogen light is not covered under the product
warranty.
Bad focus
Focus has not been
correctly adjusted Adjusting the camera manually till the image views
clear.
Noisy images Video images may be
noisy if you are using
Wireless Network IP
Camera in a very low
light environment To solve this problem, you need more light. Use the
back light function.
If not helpful, you may wish to consider replacing
the basic lens with a more sensitive lens, if the
lighting conditions within the installation area can
not be improved
Bad quality images The Display Properties
are incorrectly
configured for your
desktop Open the Display Properties in your desktop and
configure your display to show at least 65’000
colors, i.e. at least 16-bit.
Note: Using only 16 or 256 colors on your computer
will produce dithering artifacts in the image.
The camera is not
Focused correctly Referring to the above, adjust the camera manually
59
NOTE
If you still have a problem after reading this information, please contact your dealer or check the
FAQ on the INTELLINET ACTIVE NETWORKING web site at http://www.intellinet-
network.com.