Intel 460T - Manual (Page 128)

123
Technical Information A P P E N D I X A
Appendix A
# linkaggr_list={(index “name”, width of the aggregated group, “state”
#
index=from 1 to 4 (4=max number of aggregated groups possible)
# name=name of the aggregated group
# width=total port width of aggregated group
# state=”enable” or “disable” (default=disable)
#
linkaggr_list={(1 “Engineering Server”, 2 “disable”) (2 “Marketing Server”, 3, “enable”)
(3 “3rd Floor Switch”, 2, “enable)}
###### Configure PVID for Untagged Ports #############################################
#
# pvid_list={(port#, PVIDvalue) (port#, PVIDvalue) ...}
#
port#=port attached to device that does not support tags
# PVIDvalue=VID of port to which you want untagged traffic routed
#
pvid_list={(2, 100) (3, 100) (6, 15)}
###### Create 802.1Q VLAN on the Switch (Static Entries) ###################################
#
# 802_1q_static_list={(VID, “VLANstring”, M/N U/T,...) (VID, “VLANstring”, M/N U/T,...)}
#
M=member port (on ingress)
# N=non member port (on ingress)
# U=untagged device (on egress)
# T=tagged device (on egress)
# Either M or N can be specified for each port; not both
# Either U or T can be specified for each port; not both
#
802_1q_static_list={(2, “VLAN2”, MT, MU, MT, NT, MT, NU, NT, NU) (10, “VLAN10”, MT, MU,
NT, NT, MT, MU, NT, MU)}
###### GVRP (Dynamic VLAN Registration) ###################################
#
# gvrp_enabled={port#, port#, ...}
# gvrp_disabled={port#, port#, ...}
#
gvrp_enabled=VLAN dynamically registered with the switch
# gvrp_disabled=VLAN not dynamically registered with the switch
#
gvrp_enabled={1, 3, 5, 7}
gvrp_disabled={2, 4, 6, 8}