Intel 460T - Manual (Page 14)

8
C H A P T E R 1 Intel Express 460T Standalone Switch Users Guide
Media Requirements
Incorrect cabling is often the cause of network performance problems. The
next two pages provide information about how to make sure your cabling is
correct.
100Base-TX
The 100Base-TX Fast Ethernet specification requires that you use CAT 5
UTP cabling to operate at 100 Mbps. If you use lower-grade cabling (CAT 3
or CAT 4), you may get a connection, but also experience data loss or slow
performance. The limit is 100 meters between any two devices.
10Base-T
The 10Base-T Ethernet specification lets you use CAT 3, CAT 4, or
CAT 5 UTP cabling. The limit is 100 meters between any two devices.
100Base-FX
The optional Fiber Module lets you connect to a switch at distances up to
400 meters (hubs up to 160 m) at half-duplex or 2 km at full-duplex. Use
62.5/125
µm multimode fiber optic cable with an SC-type fiber optic
connector.
1000Base-T
The 1000Base-T Gigabit specification requires that you use CAT 5 UTP
cabling to operate at 1000 Mbps. If you use a lower grade cabling you will
experience either no connection or extreme data loss. The maximum
distance between any two devices is 100 meters.
1000Base-SX/1000Base-LX
The optional 1000Base-SX and 1000Base-LX Gigabit Modules provide a
high-speed connection to another device at distances up to 5 km. The
maximum distance depends on the type of cable used. Refer to the following
table for a list of cable types and maximum distances. Use cables with an
SC-type fiber optic connector.
NOTE:
100 meters = 330 feet
200 meters = 660 feet
500 meters = 1,650 feet
2 km = 2000 meters = 6,600 feet
5 km = 5000 meters = 16,500 feet