Intel 460T - Manual (Page 130)

125
Technical Information A P P E N D I X A
Appendix A
List of Factory Defaults
• Software upgrade mode: Network
• TFTP Server Address: 0.0.0.0
• Load configuration file: Disabled
• Console baud rate: 9600
• Console port data bits : 8
• Console port stop bit: 1
• IGMP Snooping: Disabled
• System port partition state: Enabled
• Lock Address Table: Disabled
• MAC Address Aging (sec): 300
• System HOL-blocking state: Enabled
• System console timeout : 15 minute
• System IGMP timeout: 300 sec
• System IP address: 192.0.2.1
• System Subnet mask: 255.255.255.0
• System Default gateway: 0.0.0.0
• System BootP request: Enabled
• Port Nway state: Enabled (Auto-Negotiate)
• Port flow control state: Auto-Negotiate IEEE
802.3x
• Port back pressure state: Auto-Negotiate
• Port priority state: Use Frame Tag
• Port HOL state: Enabled
• Ping IP address: 0.0.0.0
• Ping repeat time: 1 time
• Ping time out: 5 sec
• Port Mirroring state: Disabled
• Port Mirroring source port: 1
• Port Mirroring destination port: 2
• System Spanning Tree state: Disabled-IEEE 802.1d
• System Bridge Max age: 20 sec
• System Bridge Hello time: 2 sec
• System Bridge Forward delay: 15 sec
• System Bridge Priority: 32768
• System aging time: 300 sec
• Per Port spanning tree path cost: 10
• Per Port spanning tree priority: 128
• Per Port state: Enabled
• Per Port spanning tree state: Enabled
• Read community string: public
• Write community string: private
• Console user account: No username
• Console user password: No password
Optional module default settings
• FX Module Port Speed: 100 Mbps
• FX Module Port Duplex: Full duplex
• FX Module Flow Control: IEEE 802.3x
• FX Module Priority: Use Frame Tag
• SX\LX Module Port Speed: 1000 Mbps
• SX\LX Module Port Duplex: Full-duplex
• SX Module Flow Control: IEEE 802.3x
• SX Module Priority: Use Frame Tag