Types 8189, 8190, 8194, 8195, 8415, 8432, and 8433, Drive bay information, Removing the drive – IBM THINKCENTER 8189 User Manual
Page 54: Types, Drive, Information, Removing
Types
8189,
8190,
8194,
8195,
8415,
8432,
and
8433
Drive
bay
information
Any
bay
that
does
not
have
a
drive
installed
has
a
static
shield
and
bay
panel
installed.
The
following
illustration
shows
the
locations
of
the
drive
bays.
The
following
list
describes
some
of
the
drives
you
can
install
in
each
bay
and
their
height
requirements:
Bay
1
and
Bay 2
-
Maximum
height:
43.0
mm
(1.7
in.)
Bay
3 ,
Bay 4 ,
and
Bay
5
-
Maximum
height:
25.8
mm
(1.0
in.)
Removing
the
drive
1.
Remove
the
cover.
See
2.
Remove
the
front
bezel
by
pushing
in
on
the
blue
plastic
tab
at
the
rear
of
the
chassis.
3.
Disconnect
the
signal
and
power
cables
from
the
drive
being
removed.
Note:
Take
note
of
the
location
of
any
cables
you
disconnect.
You
might
have
to
disconnect
cables
to
other
drives
to
gain
access
to
the
drive
you
are
removing.
48
Hardware
Maintenance
Manual