Interphase Tech iSPAN 5535 PRI - Manual (Page 163)

When using this index, keep in mind that a page number indicates only
where referenced material begins. It may extend to the page or pages
following the page referenced.
iSPAN PRI PCI ISDN Users Guide 143
Index
A
adapter
connecting to an MVIP bus .......... 14
connecting to the network ............ 25
driver installation .................. 27 , 32
faceplate and connector pinouts .... 25
inspecting ................................... 7
installing hardware ...................... 9
LEDs ......................................... 67
overview ..................................... 1
specifications ............................. 77
standards compliance ................... 3
WAN setup .......................... 34 , 52
adding a RAS device ....................... 38
addressing, IP ............................... 123
AIS LED ...................................... 111
alarm LEDs .................................. 111
alarms, ISDN layer 1 ....................... 85
B
B channels
setting up ................................... 38
watching .................................... 84
basic rate interface ........................ 125
BPV LED ..................................... 112
C
cabling requirements
E1/PRI ....................................... 23
changing the watch mode ................. 86
channels
editing settings ........................... 87
setting up as RAS ports ............... 38
watching
ISDN B ................................. 84
ISDN D ................................ 82
clock modes, setting ...................... 106
common tasks, quick reference ....... 115
communication events, LoopTest ..... 92
configuring port usage .................... 39
configuring the switch type ............. 57
connecting to an MVIP bus ............. 14
connecting to the line ...................... 17
E1
cabling requirements .............. 23
connection method ................. 23
T1
connecting directly to the line with
no CSU .................... 18
directly with an internal CSU .. 19
link requirements ................... 22
connecting to the network ............... 25
connector pinouts ..................... 24 , 25
conventions
icon .......................................... vii
text .......................................... viii
CRC type, selecting ........................ 58
CS LED ........................................ 112
D
D channel, watching ....................... 82
displaying LoopTest events ............. 92
drivers
general description ....................... 5
installing ................................... 28
removing ................................... 46
DS1 properties, editing ................... 58
E
E1 connection ................................ 23