IBM Partner Pavilion T400F User Manual

Page 36

Advertising
background image

Table 6. ID settings that provide additional Loop IDs (continued). The table lists the AL_PAs, corresponding LIDs,
and definitions of the jumpers on the connector pins. Feature Switch 3 must be set to ON.

AL_PA

LID

Pin

(see Notes)

AL_PA

LID

Pin

(see Notes)

1

2

3

4

5

6

7

1

2

3

4

5

6

7

3C

5F

G

-

G

G

G

G

G

SA

7E

G

G

G

G

G

G

-

3A

60

G

G

-

-

-

-

-

SA

7F

G

G

G

G

G

G

G

Notes:

1. G means that the pin is jumpered to ground.

2. - means that the pin is not jumpered.

3. SA means soft addressing.

Step 4. Change the Link Services of the Drive (optional)

You can optionally change the link services (for example, the speed and type of
topology) of your Fibre Channel drive. If you choose not to alter the link services,
the drive defaults to a negotiated speed and operation in an FC-AL topology with a
direct connection to the server.

In the following procedure, note that:

v

Pin 5 is disconnected and is not represented in Table 7.

v

Pin 9 is ground.

To change the type of topology and the speed of the Fibre Channel drive:
__ 1. Determine the type of topology in which you want to operate the Ultrium 2

Tape Drive and refer to Table 7 for its corresponding pin configuration.

__ 2. Determine the speed at which you want the Ultrium 2 Tape Drive to operate

and refer to Table 7 for its corresponding pin configuration.

__ 3. Locate the Fibre Channel (FC) configuration/status connector on the drive

(see

1 in Figure 7 on page 25).

__ 4. Place jumpers on the pins that you identified in steps 1 and 2.

Table 7. Topology and speed settings for the Ultrium 2 Tape Drive

Fibre Channel
Characteristic

Pin

1

2

3

4

5 through 8

Speed Selection

Drive uses VPD values that
can be updated by the LDI
or RS-422 (the default
value is Negotiated)

-

-

X

X

X

2 Gb (200 MB/s)

-

G

X

X

X

1 Gb (100 MB/s)

G

-

X

X

X

Negotiated (the drive
automatically negotiates to
the highest common speed)

G

G

X

X

X

Topology Selection

Drive uses VPD values that
can be updated by the LDI
or RS-422 (the default
value is the NL_port)

X

X

-

-

X

24

IBM TotalStorage LTO Ultrium 2 Tape Drive

Advertising
This manual is related to the following products: