Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 17)

13
4
BASIC OPERATION
TV screens cannot be selected by pushing [MODE]. See p.
34 for TV operation details.
■ Display backlighting
The receiver has display backlighting with a 5 sec. timer for
nighttime operation. The display backlighting can be turned
ON continuously or turned OFF, if desired.
➥ Push any switch except [FUNC]; or, rotate [DIAL] to turn the
backlighting ON.
• When auto backlighting is set, the backlighting will automatically
turn OFF when switches and [DIAL] have not been operated for 5
sec.
◊
Setting the backlighting condition
q Push [FUNC] + [(MODE) SET] momentarily to enter set
mode.
• Select a non-band scope screen in advance for color LCD.
w Rotate [DIAL] until “LIGHT” appears.
• “LIGHt” disappears after 1 sec. and the previously selected back-
lighting timer and “LI” appears when color LCD is OFF.
e Push [ ↔ ] or rotate the tuning dial while pushing [FUNC] to
select the desired backlighting condition.
r Push [(MODE) SET] to exit set mode.
Pause Scan : 10SEC
Priority : OFF
Beep Audio : VOLUME
Light : AUTO
A.Power OFF : OFF
Pause Scan : 10SEC
Priority : OFF
Beep Audio : VOLUME
Light : AUTO
A.Power OFF : OFF
Pause Scan : 10SEC
Priority : OFF
Beep Audio : VOLUME
Light : OFF
A.Power OFF : OFF
Automatic backlighting Backlighting set
mode Continuously OFF
FM W FM W
RX RX
FM TV mode
(ATV type only) TV screen
frequency selection