Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 18)

■ General
The receiver has 400 memory channels in 8 banks (A–H) for
storage of often-used frequencies.
◊
Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency (p. 8)
• Receive mode (p. 12)
• Tuning step (p. 8)
• Memory name (p. 17)
• Duplex direction (DUP or – DUP) with an offset frequency
(p. 31)
• Tone squelch ON/OFF (p. 28)
• Tone squelch frequency (p. 28)
• Scan skip setting (p. 22)
■ Programming during selection
q Push [ ↔ ] to select an operating band.
w Set the desired frequency:
➥ Set the frequency using [DIAL].
➥ Set other data (e.g. offset frequency, duplex direction,
tone squelch frequency, etc.), if required.
e Push [V/M] for 1 sec. to indicate memory channels.
• Do not hold [V/M] for more than 2 sec., otherwise the previously
selected memory channel will be overwritten.
r Rotate [DIAL] to select the desired channel.
• VFO (VF), as well as regular memory channels, can be pro-
grammed in this way.
• Rotate [DIAL] while pushing [FUNC] to select a memory bank
(A–H), programmed scan edge channel or VFO (VF).
t Push [V/M] for 1 sec. to program.
• Keep pushing for 2 sec. or more to automatically select the next
memory channel, if desired.
14
5
MEMORY CHANNELS
FM DUP TSQL
P
FM
V/M SKIP V/M SKIP
FUNC
FM DUP TSQL
P
S1 3 5 7 9
VOL
FM PSKIP TSQL –DUP
145.600.000
TS 15.0
S1 3 5 7 9
VOL
FM
146.010.000
M:A00
TS 15.0
S1 3 5 7 9
VOL
. .
M:E40
TS .
S1 3 5 7 9
VOL
FM PSKIP TSQL –DUP
145.600.000
E41
TS 15.0
for 1 sec.
blank
channel
for 2 sec.
for bank
selection for CH
selection
+
[EXAMPLE]: Programming ch 40 of memory bank E during selection (and ch 41 selection).