Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 28)

24
6
SCAN OPERATION
■ Frequency skip function
◊
Programming a skip frequency
Unwanted frequencies can be skipped and programmed as
skip channels when full scan, band scan or programmed scan
is pausing.
q Start full scan, band scan or programmed scan. (p. 19)
w While receiving an unwanted signal and scan pauses,
push [FUNC] + [(V/M) SKIP] for 2 sec. to program the re-
ceived frequency as a skip frequency.
• The receiver emits 3 beeps and the scan resumes.
• Non-programmed memory channels (blank channels) are used
for skip frequency programming in reverse sequence.
• To scan the skip frequency after programming, cancel the skip
information (p. 22) or clear the memory channel (p. 16).
◊
Frequency skip function ON/OFF
The frequency skip function can be turned OFF. In this case,
the frequencies will not be skipped even if skip information is
programmed and “P SKIP” or “P
" ” does not appear.
q Select VFO mode with [V/M].
w Push [FUNC] + [(V/M) SKIP] to toggle the frequency skip
function ON or OFF.
• “PSKIP” or “P " ” appears when the function is turned ON.
FM FM
P
S1 3 5 7 9
VOL
FM
146.010.000
TS 15.0
S1 3 5 7 9
VOL
FM PSKIP
146.010.000
TS 15.0
The frequency skip
function is OFF. The frequency skip
function is ON.
FM
P RX
FM
P RX
S1 3 5 7 9
VOL
RX
FM PSKIP
370.475.000
2P
TS 15.0
S1 3 5 7 9
VOL
RX
FM PSKIP
370.475.000
H49
TS 15.0
Indication while programming Indication while pausing