Intermec PK80 - Manual (Page 32)

Operation Chapter
—
2
20 PK80 Series 80-Column User’s Manual
Adjust the Pinfeed Holders
Note: There are two pinfeed holders, one next to the green thumb wheel
and one opposite the same wheel. Always loosen the pinfeed holder oppo-
site the green thumb wheel.
Adjusting the pinfeed holder next to the green thumb wheel may cause
information to print in the wrong place. If this pinfeed holder is moved,
correct its location by releasing the pinfeed holder tab, moving the pinfeed
holder as close to the green thumb wheel as possible, then locking the
pinfeed holder tab, before adjusting the opposite pinfeed holder.
If the paper does not properly fit on the two pinfeed holders Follow these
steps to adjust the area between the two pinfeed holders to fit the width of
the paper. See the illustration on the next page.
1 With the pinfeed holders open, release the locking tab on the pinfeed
holder opposite the green thumb wheel.
2 Adjust the pinfeed holders to align the pins with the paper.
3 Close the pinfeed holder.
4 Ensure that the paper is smooth (no folds, bulges, bows, etc.) between
the pinfeed holders. If so, push the locking tab down on the pinfeed
holder that you adjusted.
2
1
3
1 Pinfeed holder
2 Locked pinfeed holder locking tab
3 Released pinfeed holder locking tab
4 Thumb wheel (green)
4