Intermec PK80 - Manual (Page 56)

Commands Appendix — A
44 PK80 Series 80-Column Printer User’s Manual
Commands
Below are the commands and the pages where their information begins:
S Bluetooth Wireless Configuration (next paragraph)
S Easy Print (page 45)
S Query (page 46)
Some of these commands are identified as Easy Print commands, which
must be preceded by ESC EZ. Printers must also receive the “{” as part of
the ESC EZ sequence to be placed into Easy Print mode.
Bluetooth Wireless Configuration Commands
All commands are enclosed in ‘{’ and ‘}’. They begin with three letters; if
there is data that follows the letters are terminated with a colon “:”. Each
parameter can be configured is identified by a unique letter, followed by a
colon, followed by the data for that parameter. If the configuration type
permits, multiple parameters can be changed in one command by separat-
ing them with a semicolon “;”. All commands must be sent in uppercase..
Spaces in the data are not allowed unless they are part of the data.
After receiving the command, the data is written to flash and the printer
restarts using the new values. This all takes less than one second.
1 Configure default values. ALL configuration parameters can reset to
their original default (non-printer specific) values by sending “{CDV}” -
Configure Default Values
2 Configure Bluetooth. As of this date, only the Bluetooth Friendly Name
can be reconfigured by sending a command of the form
“{CBT:<parms>}”
S F: <data> for Friendly Name (Device Name)
Send up to 16 characters.
S D: <data> for Discoverable (<data> = Y/N)
S C: <data> for Connectable (<data> = Y/N)
S B: <data> for Bondable (<data> = Y/N)
S E: <data> for Encryption (<data> = Y/N)
S A: <data> for Authentication (<data> = Y/N)
S P: <data> for Passkey
Send up to 16 characters (default passkey is “passkey”)
S I: for Inactivity Timeout (see pages 22 and 55 for more information)