JVC KD-DV5000 - Manual (Page 47)

47
ENGLISH
SOUND ADJUSTMENTS
Operations of this section are explained using
the buttons on the control panel unless
mentioned otherwise.
Adjusting the sound
You can adjust the sound characteristics to your
preference.
• “Vol Adj” setting is required for each source
except FM. Before starting “Vol Adj,” select an
appropriate source for which you want to make
an adjustment.
1
Select the item you want to adjust.
Each time you press the button,
the adjustable items change as
follows:
Note:
You can also use the SEL button on the remote
controller to call up the fader/balance
adjustment screen.
Indication To do: Range
Fad* Adjust the front R06 (Rear only)
and rear speaker |
balance. F06 (Front only)
Bal Adjust the left L06 (Left only)
and right speaker |
balance.
R06 (Right only)
Vol Adj Adjust and store –12 (min.)
the input level |
of each source. +12 (max.)
2
Make adjustments.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time, by referring to the
indication on the display.
• Press 5 (up) or ∞ (down)
to adjust the fader.
• Press ¢ or 4
to adjust the balance.
Note:
You can also use the ¢ or 4
buttons and FOLDER PRESET 5 (up) or
FOLDER PRESET
∞ (down) on the remote
controller for adjustment.
• To adjust the input level of each source
—Vol Adj:
This setting is required for each source
except FM. Before making an adjustment,
select an appropriate source for which you
want to make an adjustment.
Once you have made an adjustment, it is
memorized, and you will not need to
adjust the volume level each time you
change the source.
Adjust to match the input level to the FM
sound level.
To decrease the level
To increase the level
SEL
* If you are using a two-speaker system, set the fader
level to “00.”
Fad (Fader)
Bal (Balance) Vol Adj
(Volume Adjustment)
Canceled
Canceled
ATT
EN47-49DV5000[J]f.p65 03.3.23, 17:34 47