JVC HR-J785EK - Manual (Page 18)

basic features 18
before you start
Turn the TV on
Tune the TV to your
Video Channel or to its
AV mode
Choose a blank
cassette which has the
record safety tab still in
place
Record
Safety Tab
Load the cassette into
the VCR (see page 14)
TV PR +
TV PR –
T V
– TV
+
TV
0000
STOP FIN
MEN U OK
TV/VCR
DAILY/QTDN. VPS/PDC
AUX
?
WEEKLY/HEBDO
PROG 30 SEC
– –:– – AUDIO
1 2 3
4 6 5
7 8 9
0
DATE START
DEBUT PR
2
4
1
3
ENTER/ENTR EE
EXPRESS
Recording
TV signals being received by the recorder’s built in tuner can be recorded
onto a video tape. You can ‘capture’ a TV programme using your VCR.
Choose a Programme
There are two ways to select a preset position of the VCR.
method one
Press PR +/– or the number keys on the Remote Control to select
the channel that you wish to record.
method two
Push the center part of the JOG Dial so that the preset position
appears on the TV screen. While the display is shown, turn the JOG Dial to the
right or left.
Set the Tape Speed
Press / and check the on-screen display until the required tape speed is
shown. You can choose between ong Play ( P) or Short Play (SP). The picture
quality on P recordings will not be as high as on SP recordings, but the tape will
last longer.
Start Recording
There are two ways to start recording:
method one
Press and hold T and then press . on the Remote Control.
method two
Press T on the VCR.
Pause and Resume During Recording
On either the VCR or the Remote Control, press | to temporarily stop recording
and press . to resume. You cannot change the preset position on the VCR while
it is recording but you can while it is paused (see
Choose a Programme at the top
of this page).
TV PR +
MENU OK
? PROG 30 SEC 1
3
ENTER/ENTR
EE
TE PR