JVC HR-J785EK - Manual (Page 41)

advanced features 41
Editing
L-2 SELECT Setting
Set L-2 SELECT to the appropriate mode depending on the type of unit connected
to the rear panel AV2 (L-2) IN/DECODER connector of this VCR.
get to the mode set screen
Press m. Move the highlight bar to MODE
SET using the A and B buttons and press O (or E).
select l-2 select mode
Move the highlight bar to L-2 SELECT using the A
and B buttons. Press O (or E) to select the desired mode:
• a/v To use this VCR as the recording deck with the player connected to the
AV2 (L-2) IN/DECODER connector, or to use the satellite receiver connected to
the AV2 (L-2) IN/DECODER connector.
• decoder To use a decoder connected to the AV2 (L-2) IN/DECODER connec-
tor.
• sat To view a satellite programme with the TV set while the VCR is turned
off.
return to normal screen
Press m.
Notes
• When L-2 SELECT is set to SAT , it is possible to view a satellite broadcast with
the TV set to its AV mode even if the VCR is turned off. When the VCR is in
the stop mode or recording, press
TV/VCR on the Remote Control to turn off
the VCR indicator on the display panel.
If you turn on the VCR when the satellite receiver’s power is off, nothing
appears on the TV screen. In this case, turn of the satellite receiver, or set the
TV to its TV mode, or press
TV/VCR on the Remote Control to set the VCR to
the video mode.
• When L-2 SELECT is set to SAT , SAT appears on the TV screen or SAt on the
display panel instead of L-2 .
• If you have a satellite receiver or a decoder connected to the AV2 (L-2) IN/
DECODER connector, be sure to set L-2 SELECT back to appropriate mode after
editing.
• If you’re not connecting a satellite receiver or a decoder to the AV2 (L-2) IN/
DECODER connector, leave L-2 SELECT set to A/V .
• The default setting is A/V ; if the VCR’s memory backup has expired due to a
power cut or because the AC was removed from the VCR, A/V will be auto-
matically selected when the power is restored to the VCR. If you are using a
satellite receiver or a decoder, be sure to set
L-2 SELECT back to appropriate
mode.