JVC HR-J785EK - Manual (Page 40)

advanced features 40
progr amme satellite receiver
Enter the details of the programme into your satellite
receiver (see receiver manual) and put a tape in the VCR.
get to the mode set screen
Press m. Move the highlight bar to MODE SET using the
A and B buttons and press O (or E).
select l-2 select mode
Move the highlight bar to L-2 SELECT using the A and B
buttons. Press O (or E) to select L-2 or SAT . Then press m.
set tape speed
Press / on the Remote Control to set the tape speed to either SP or LP .
engage vcr in auto mode
Press and hold SAT c on the VCR for about 2 seconds. The SAT c
indicator on the VCR display panel lights up and the VCR turns off automatically. Any signal
detected at the
AV2 (L-2) IN/DECODER connecter will automatically start the VCR recording; when
the signal stops, so will the VCR.
Notes
connectors
Auto Satellite Prog Recording is only possible using the AV2 (L-2) IN/DECODER
connector.
timer mode
You cannot put the VCR into TIMER MODE when using Auto Satellite Prog
Recording Mode.
r The number of programmes recorded will not be displayed on the VCR display
panel when the r button is pressed.
timer recording
Auto Satellite Prog Recording is not possible if your satellite receiver does
not have a timer.
indic ator The SAT c indicator light flashes when Auto Satellite Prog Recording is in progress.
disengage
To disengage the VCR during Auto Satellite Prog Recording, press the o button.
The VCR will stop recording and turns off.
tape speed
When recording two or more programmes consecutively, you cannot set a different
tape speed for each programme. The first speed selected will apply to all programmes in that
recording session.
b.e.s.t.
The B.E.S.T. system will not work during Auto Satellite Prog Recording.
just clock Just Clock does not work when in Auto Satellite Prog Recording mode.
incoming signal
The VCR will only react to the start of an incoming signal at the AV2 (L-2)
IN/DECODER connecter. If you try to engage Auto Satellite Prog Recording Mode whilst the
satellite receiver is powered on, the SAT c indicator light will flash but the VCR will not record.
You must power the satellite receiver off then on again to begin recording in these circumstances.
c able input
You can record in the same way from a cable system as long as you connect the
cable system has a timer on/off function and is connected to the AV2 (L-2) IN/DECODER .
incompatibilities
Some satellite receivers output signals even when turned off. These receiv-
ers cannot be used with this VCR in this way.