Janome MEMORY CRAFT 4800 User Manual
Page 44
43
Darning
1
Stitch pattern:
22
2
Presser foot:
Automatic buttonhole foot R
3
Darning shape:
(See below for settings.)
•
To sew:
[1]
Pull the button holder to the rear.
[2]
Place the garment under the foot. Press the Up/down
needle button twice. Raise the foot.
Remove the fabric to the left to draw both threads
under the foot and put the fabric back under the foot.
[3]
Lower the foot. Press down the foot control. The
machine will lock stitch, sew 16 rows of darning, lock
stitch again and the machine will stop automatically.
*
The size of one darn cycle is variable. However, the
maximum stitch length is 2 cm (3/4”) and the maxi-
mum stitch width is 7 mm (9/32”).
[4]
Turn the fabric and repeat sewing for reinforcement.
1
Button holder
2
Starting point
3
2 cm (3/4”)
4
0.7 cm (9/32”)
•
For darning less than 2 cm
Switch to “Low” speed setting. 4 lock stitches will be sewn
first. Then sew to the desired length and press the reverse
button. The desired length has now been determined.
Continue sewing until the machine stops automatically.
5
Reverse button
6
Desired stitch length
•
To memorize darning stitches
When repeatedly sewing the same-size darn to repair a
side rip or belt loop, press “Memory” key and restart sew-
ing.
•
Adjusting the shape of darning stitches
If one side of the darn is higher than the other, make them
even by pressing the stitch length “+” or “-” key.
When you press the “+” or “-” key, d3 will be indicated
automatically.
You can adjust the shape of the darn by pressing “+” or
“-” key, d1 to d5.
7
When the left side is lower
8
Select “d1” or “d2” to balance the stitches.
9
When the right side is lower.
10
Select “d4” to “d5” to balance the stitches.
1
2
3
1
2
3
4
2
5
6
2
7
8
9
10
[1] [2][3]
[4]