Janome MEMORY CRAFT 4800 - Manual (Page 55)

54
Twin Needle Stitching
1 Stitch pattern: 95
2 Presser foot: Satin stitch foot F
This machine is equipped with a twin needle that can be
used to sew parallel rows straight on decorative stitches
adding an exquisite touch to table linens and clothing.
* Stitch patterns
(01,05,31,33,34,41,45,47,56,57,59,86,95) can also
be used.
Turn off and unplug the machine before changing the
needle to the twin needle.
Insert the additional spool pin, and put the felt and spool
on it with the thread coming off the spool as shown. (see
page 17)
When threading the machine for twin needle sewing
follow this chart making sure you separate the threads,
placing one in each thread guide on the sides of the bar.
1-4 Threading steps from 1 to 4 are the same as for
single thread.
* The additional spool thread should roll out
counterclockwise as shown.
5 Slide one of the threads through the needle bar
thread guides, on the left and the other one on the
right.
6 Thread the needles from front to back.
7 Turn the power switch on, select the stitch pattern
and press the twin needle stitch key.
* At corners, raise the needle till they clear the fabric.
Partially raise the presser foot and carefully pivot the
fabric.
When twin needle sewing is completed, change
needle and reset tension if necessary and press twin
needle key to disengage twin needle function.
* The needle threader cannot be used with twin
needles.
1 2
3
1
2
5
6
4