Janome MEMORY CRAFT 4800 - Manual (Page 65)

64
Care of Your Machine
1 Screw driver 2 Set screw
3 Needle plate 4 Bobbin holder
5 Lint brush 6 Feed dogs
7 Hook race 8 Soft, dry cloth
Press the needle Up/down button to raise the needle and
unplug the machine before cleaning.
Do not dismantle the machine other than explained on
this page.
Do not store the machine in a high-humidity area, near a
heat radiator or in direct sunlight.
Clean the outside of the machine with a soft cloth and
neutral soap.
Cleaning the Hook Race and Feed Dogs
[1] Remove the presser foot and needle. Remove the
screw on the left side of the needle plate with the
screwdriver supplied with the machine.
[2] Remove the needle plate and take out the bobbin.
Lift up the bobbin holder and remove it.
[3] Brush out dust and lint inside the bobbin holder.
[4] Clean the feed dogs and the hook race with the lint
brush.
[5] Clean the inside of the bobbin holder with a dry cloth
or a lint brush.
* Wipe out gently with soft, dry cloth. You may also
use a vacuum cleaner.
Replacing the Bobbin Holder
1 Bobbin holder
2 Stopper
3 Knob
4 Needle plate guide pins
5 Screwdriver
6 Guide holes
[1] Insert the bobbin holder so that the knob fits next to
the stopper in the hook race.
[2] Insert the bobbin.
[3] Replace the needle plate, inserting the two needle
plate guide pins into the holes in the needle plate.
Replace the screw.
[1]
[2]
[3]
[4]
[5]
[1] [2]
[3]
SECTION V CARE OF YOUR MACHINE
1
1
2
3
4
5
6
2
3
4
5
4
5
6
7
8