Voice control – Jaguar SEMCON JLR XJ User Manual

Page 129

Advertising
background image

R

(FM8)

SEMCON JLR OWNER GUIDE VER 1.00

NAS

LANGUAGE: english-NAS-en;

MARQUE: jaguar;

MODEL: XJ

Voice control

129

VOICE TUTORIAL

To listen to a tutorial detailing the operation of
the Voice system:
• Briefly press the Voice button to start a

voice session.

• Wait for the tone to sound, then say Voice

tutorial.

The voice tutorial can be cancelled at any time
by selecting Cancel on the on-screen pop-up
or by pressing and holding the Voice button.

VOICE TRAINING

This is a feature designed to enable the system
to better recognize the vocal characteristics of
a user, once the training has been completed.
To carry out Voice training:
• Select Setup from the Home menu.
• Select Voice and from the Setup menu.
• Select Voice training from the Voice

settings menu.

• Select User 1 or User 2, to start the

training.

• Follow the on-screen and audible

instructions.

The training session can be cancelled at any
time by selecting Cancel from the on-screen
pop-up or by pressing and holding the Voice
button.

VOICE SESSION INTERRUPTIONS

Certain conditions will cause the current voice
session to be cancelled, as follows:
• If a high priority warning appears in the

message center.

• If there is no user input for a sustained

length of time.

• Pressing any hard or soft button.
• Changes in cruise control.
After four seconds, you may press the Voice
button to start a new voice session.

VOICETAGS

Voicetags enable the user to personalize the
Voice system so that a single name can be used
to call-up a navigation destination, telephone
number or radio channel.

To add a Voicetag:
• Select Setup from the Home menu.
• Select Voice from the Setup menu.
• Select Voicetags from the Voice settings

menu.

• Select the system which the Voicetag is to

activate (Phone, Navigation or Radio).

Follow the on-screen and audible instructions.

NAVIGATION POI VOICE COMMANDS

To request the display of POI (Point Of Interest)
identifiers on the navigation display, say the
command Navigation, followed by the name of
the desired POI category from the list below
(e.g. Navigation Parking).

Icons will appear on the navigation display,
indicating the locations of the selected POI. For
further information about POIs, see 143,
CATEGORIES AND SUB-CATEGORIES
.

Advertising