JVC DR-M7S - Manual (Page 79)

Masterpage:Right-No-Heading
EN
79
Filename [DR-M7SE_10Editing.fm]
Page 79 March 26, 2004 3:52 pm
Edit To Or From
Another Recorder
You can use your unit as the source player or as the
recording deck.
A
Make connections.
Connect the player’s 21-pin SCART connector to the
unit’s 21-pin SCART connector as illustrated.
A When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording
deck.
B When using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER
connector to the source player.
● If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set “L-1
OUTPUT” to “SCART S-VIDEO”. (
੬
pg. 80, “L-1 Output and
L-1 Input Setting (L-1 OUTPUT and L-1 INPUT)”)
— when using your unit as the recording deck, set “L-2
SELECT” to “S-VIDEO”. (
੬
pg. 81, “L-2 Select Setting
(L-2 SELECT)”)
B
Set the input mode of recording deck.
With this unit, press PR +/– to select “L-1” for the L-1 IN/
OUT connector, or “L-2” for the L-2 IN/DECODER
connector, depending on the connector being used.
● When using another recorder as the recording deck, refer to its
instruction manual.
● When using the L-2 IN/DECODER connector, set “L-2
SELECT” to “VIDEO” or “S-VIDEO”. (
੬
pg. 81, “L-2 Select
Setting (L-2 SELECT)”)
C
Set the recording speed.
Press REC MODE repeatedly until the desired recording
speed appears.
D
Start the source player.
Engage the Play mode of the source player.
E
Start the recording deck.
Engage the Record mode of the recording deck.
F
Stop dubbing.
Stop recording on the recording deck, then stop playback
on the source player.
NOTES:
● All necessary cables can be obtained from your dealer.
● For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
● When you use this unit as the source player for editing, be sure
to set “SUPERIMPOSE” to “OFF” before starting. (
੬
pg. 93)
● If you are using another recorder with S-Video and Audio
output connectors, connect its S-Video and Audio output
connectors to this unit’s S-VIDEO and AUDIO input
connectors on the front panel. Then, set the unit’s input mode
to “F-1” in step
B, and set “F-1 INPUT” to “S-VIDEO”.
(
੬
pg. 81, “F-1 Input Setting (F-1 INPUT)”)
21-pin SCART cable
(provided)
Recorder
Your unit
Another recorder
Player
TV receiver
21-pin SCART cable
(not provided)
Recorder Your unit
Another recorder
Player
TV receiver
21-pin SCART cable
(not provided)
21-pin SCART
cable
(provided)
Slide the TV/CABLE/SAT/DVD switch to DVD.
DR-M7SE_01.book Page 79 Friday, March 26, 2004 4:27 PM