JVC CA-HXZ55D - Manual (Page 52)

47
English
IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly. Thus, during
recording you can adjust the sound you are actually listening to
without affecting the recording level.
• If there are excessive noise or static in the recording you have
made, the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can only use type I tape for recording.
To protect your recording
Cassettes have two small tabs on
the back to protect from
unexpected erasure or re-recording.
To protect your recording, remove
these tabs.
To re-record on a protected tape,
cover the holes with adhesive tape.
Recording on a Tape
1
Press
0 EJECT and insert a recordable cassette
with the exposed part of the tape down.
2
Close the cassette holder gently.
• If you want to record on both sides of a tape, see “To record
on both sides—Reverse mode.”
3
Check the tape direction of the cassette deck.
• If the tape direction is not correct, press TAPE 2 3 twice then
press 7 to change the tape direction.
4
Start playing the source—FM, AM, disc player,
or auxiliary equipment connected to the AUX IN
jacks.
• When the source is the disc player, you can also use
Synchronized Recording (see page 48).
5
Start recording.
On the remote control:
Press and hold REC while holding down SHIFT
for more than 1 second.
On the front panel:
Press REC START/STOP.
The REC (recording) lamp start flashing when recording starts,
and the tape direction indicator (
3 or 2) starts flashing slowly.
• If no cassette is inserted, “NO TAPE” appears on the display.
If a protected tape has been inserted, “NO REC” appears on
the display.
To stop recording immediately, press 7 (or REC START/STOP or
7 on the front panel).
To remove the cassette, press 0 EJECT to open the cassette holder.
To record on both sides—Reverse mode
On the remote control:
Press REV. MODE while holding down SHIFT.
On the front panel:
Press REVERSE MODE.
The Reverse mode indicator lights up on the display like— .
• When using the Reverse mode for recording, start recording in the
forward ( 3) direction first. Otherwise, recording will stop when
only one side (reverse) of the tape is recorded.
To cancel the Reverse mode, press the button again so that the
Reverse mode indicator lights up on the display like—
.
Recording
(continued)
46-52HX-Z77&55[U]6.p65 03.8.18, 10:43 AM 47