Jaguar Touch Screen Display JJM 18 42 26 701 - Manual (Page 24)

Climate Control
24
L
Ignition On
The climate control system operates in
position ‘II’ (run) of the ignition switch.
When the ignition is switched to run or the
engine is started, the Jaguar logo will be
displayed briefly followed by the last
touch-screen selected (e.g. radio).
The climate control system will be set to
the climate operating mode selected
previously.
Climate Control Displays
There are two climate control
touch-screen displays, one for the system
‘ON’ state and the other for system
‘OFF’/ram air mode. Smaller pop-up
displays appear briefly when selecting air
recirculation or adjusting the blower
speed.
Most climate functions can be selected
using the perimeter buttons without
displaying the climate touch-screen
buttons.
To select the touch-screen
display, press the CLIMATE
button.
To exit the climate control screen, select
another system function, e.g. AUDIO.
AUTO Mode
Automatic operation provides a
controlled environment over a
temperature range of 61°F to 89°F
(17°C to 31°C) and should be regarded as
the normal operating mode.
To select automatic climate
control press the AUTO button
and select the required
temperature.
The AUTO mode touch-screen is shown
above. If the touch-screen is not
displayed, press the CLIMATE button.
Front and rear screen heating and timed
air recirculation may be selected while
remaining in AUTO mode. Selecting any
other climate control perimeter button or
touch-screen button will cancel AUTO
operation.
Automatic operation cannot be
deselected using the AUTO button. To
exit AUTO mode, select another climate
mode or touch the system ON/
OFF button to switch the system off.