Janome MEMORY CRAFT 9700 - Manual (Page 12)

10
WRNING:
Turn the Power Switch OFF before changing the
presser foot.
Button Sewing Foot T
To Attach:
Insert the Rear Pin on the foot into the Groove of the
Foot Holder.
Gently lower the presser bar, holding the foot with your
fingers.
1 Rear Pin
2 Groove of the Foot Holder
Darning Foot P-2
To Attach:
Loosen the thumb screw and remove the Foot Holder.
Attach the Darning Foot P-2 to the presser bar putting
the Pin on the Needle Clamp Screw.
Tighten the thumb screw firmly with the screwdriver.
3 Darning Foot P-2
4 Pin
5 Needle Clamp Screw
Embroidery Foot P
To Attach:
Loosen the thumb screw and remove the Foot Holder
to the rear.
Attach Embroidery Foot P to the presser bar from
behind.
Tighten the thumb screw securely with the
screwdriver.
6 Embroidery Foot P 6
5
4 3
1
2