Janome MEMORY CRAFT 9700 - Manual (Page 14)

12
Winding the Bobbin
Removing the bobbin
1 Slide the Hook Cover Plate Release Button to the
right, and remove the Hook Cover Plate.
1 Hook Cover Plate Release Button
2 Hook Cover Plate
2 Lift out the Bobbin from the Bobbin Holder.
3 Bobbin
Setting the Spool of Thread
Lift up the Spool Pin. Place the spool of thread on the
Spool Pin with the thread coming off the spool as
shown. Attach the Large Spool Holder, and press it
firmly against the spool of thread.
NOTE:
Use the Small Spool Holder to hold narrow or small
spools of thread.
Additional Spool Pin
Use the Additional Spool Pin when you need to wind
the bobbin without unthreading the machine while
working on a sewing project.
Insert the Additional Spool Pin into the Spool Stand
and then into the Hole beside the horizontal spool pin.
Place the Felt on the spool pin and place a spool of
thread on it as shown.
4 Additional Spool Pin
5 Felt
6 Hole
7 Spool Stand
1
2
3
5
4
6
6
1
2
7