Janome MEMORY CRAFT 9700 - Manual (Page 48)

46
Corded buttonhole
To sew the corded buttonhole, follow the same
procedure as for the Sensor Buttonhole; refer to the
instructions on pages 43 to 45.
Select the pattern 13.
With the Automatic Buttonhole Foot R raised, hook the
filler cord on the Spur on the back of the buttonhole
foot.
Bring the ends of cord toward you under the
buttonhole foot clearing the front end.
Hook the ends of the filler cord into the Forks on the
front of the Automatic Buttonhole Foot R, to hold them
tight.
1 Spur
2 Forks
Lower the needle into the garment where the
buttonhole will start and lower the foot.
Press the Start/Stop Button and sew the buttonhole.
Each side of the buttonhole and the bartacks will be
sewn over the cord. The machine stops automatically
when finished.
Remove the fabric from the machine and cut the
sewing threads only.
Pull the left end of the filler cord to tighten it.
Thread the end of the cord through a darning needle
and draw it to the wrong side of the fabric and cut.
NOTES:
Set the stitch width in accordance with the thickness
of the cord used.
To cut the buttonhole opening, refer to the instructions
on page 45.
2
1
A Z
Sensor BH
14 15 16 17 18
19 20 21 22 23 24
R
SET
Adjust
Pull down BH Lever.
Auto
Auto 3
Sensor
13
SET