Janome MEMORY CRAFT 9700 - Manual (Page 16)

14
Inserting the Bobbin
1 Place the Bobbin in the Bobbin Holder with the
Thread running off counterclockwise.
1 Thread
2 Bobbin Holder
2 Guide the thread into the Front Notch (A) on the
front of the Bobbin Holder.
3 Draw the thread to the left, sliding it between
the tension spring blades.
4 Continue to draw the thread lightly until the thread
slips into the Side Notch (B).
5 Pull out about 10 cm (4") of thread to the rear.
NOTE:
A Threading Chart is shown on the Hook Cover Plate
for your reference.
Reattach the Hook Cover Plate.
3 Threading Chart
5
3
1
2
(A)
2
3
(B)
4
(B)
1