Janome MEMORY CRAFT 9700 - Manual (Page 80)

78
1
2
3
1
START
STOP
1
2
Attaching the Embroidery Hoop to the
Machine
Turn the Attaching Knob so it is parallel with the metal
plate, and set the hoop on the Carriage.
Attach the hoop by fitting the Pins into the Carriage
Holes.
1 Attaching Knob
2 Carriage Holes
3 Pins
Turn the Attaching Knob clockwise.
CAUTIONS:
Always provide sufficient clearance for the embroidery
carriage behind your machine before starting
embroidery.
Never try to move the carriage by hand or touch the
carriage while it is moving.
Make sure to return the carriage to the home position
before turning the power off.
Thread Holder
To avoid sewing on the needle thread, place the thread
end on the Thread Holder.
Pass the needle thread through the Hole in the
Embroidery Foot and draw it up to the thread holder.
Hang the thread on the thread holder from the front to
back.
1 Hole in the Embroidery Foot
2 Thread Holder