JVC KT-SR3000 - Manual (Page 24)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
24
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
How the S-Seek function works
Your JVC PnP automatically searches for the
incoming signal to determine if a match exists
between the signal and the PDTs stored in memory
(except the ones with “S-Seek” set to “Off”: see the
next page).
• If one or more matches are found, “S-Seek Alert”
appears for a while, and a beep sounds.
• The current channel will continue to play until you
select a new channel.
P
If you have already stored 20 PDTs...
“S-Seek Full” will flash on the display for a while,
then the “Replace-Cancel” screen appears.
1. Press CH
5 / ∞ (or CH + / –) to select either
“Replace” or “Cancel”, then press SEL (or
SELECT).
• Replace: To select a previous PDT to be replaced
with the new PDT.
After pressing SEL (or SELECT), the following
screen appears.
P
Press CH
5 / ∞ (or CH + / –) to select an
unnecessary PDT, then press SEL (or SELECT).
It will be replaced with the new PDT.
• Cancel: Not to store the new PDT.
The original screen will be resumed.
KT_SR3000_15_25.p65 05.8.22, 2:07 PM 24