JVC KT-SR3000 - Manual (Page 34)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
34
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Channel:
Press CH
5 / ∞ (or CH + / –) to select a channel on
the channel list shown on the screen, then press SEL
(or SELECT).
Program Alert On/Off:
Press CH
5 / ∞ (or CH + / –) to select either
“Program Alert On” or “Program Alert Off”, then
press SEL (or SELECT).
Auto Shutdown
You can make your JVC PnP shut off automatically if
no operation is done for about one hour.
A beep sounds just one minute before your JVC PnP
shuts off, and the “Cancel Auto Shutdown” screen
will be shown (see note below).
To activate (or deactivate) Auto Shutdown
Press CH
5 / ∞ (or CH + / –) to select “Enabled” (or
“Disabled”), then press SEL (or SELECT).
Note: When the “Cancel Auto Shutdown” screen is
shown on the display, pressing SEL (or SELECT)
will temporarily cancel Auto Shutdown.
Sleep Mode
You can specify the time until your JVC PnP shuts
off—“Sleep Off”, “15 Minutes”, “30 Minutes”, “45
Minutes” and “60 Minutes”.
Press CH
5 / ∞ (or CH + / –) to select the time, then
press SEL (or SELECT).
Your JVC PnP will now turn off after the selected
time has passed.
• If “Sleep Off” is selected, Sleep Mode is canceled.
~ Factory Default
You can reset the following items to the default
settings.
Press CH
5 / ∞ (or CH + / –) to select “Yes” (to
reset) or “No” (to cancel the reset), then press SEL (or
SELECT).
KT_SR3000_26_35.p65 05.8.22, 2:08 PM 34