JVC KT-SR3000 - Manual (Page 25)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
25
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Then the S-Seek Alert List screen which displays the
current matches appears.
• Press CH
5 / ∞ (or CH + / –) to select an entry
on the S-Seek Alert List screen, then press SEL
(or SELECT).
Note: If no operation is done for about 10
seconds, your JVC PnP automatically exits from
the S-Seek Alert List screen.
To delete or deactivate the PDT for S-Seek
1. Press and hold MEMO (memory) for about 3
seconds.
The most newly stored PDT appears on the display.
2. Press CH
5 / ∞ (or CH + / –) repeatedly to select
an unnecessary PDT, then press SEL (or SELECT).
The following screen appears.
3. Press CH
5 / ∞ (or CH + / –) to select either
“Delete” or “S-Seek”, then press SEL (or
SELECT).
• Delete: To delete an unnecessary PDT.
After pressing SEL (or SELECT), the Delete
Confirmation screen appears.
– Select “Yes” (to delete) or “No” (to cancel
deletion) by using CH
5 / ∞ (or CH + / –) and
then SEL (or SELECT).
• S-Seek: To deactivate the PDT for S-Seek
function.
After pressing SEL (or SELECT), the S-Seek
Setting screen appears.
– Select “Off” (to deactivate the PDT for S-Seek)
or “On” (to activate the PDT for S-Seek) by
using CH
5 / ∞ (or CH + / –) and then SEL (or
SELECT).
• To exit from this screen without changing settings,
press MEMO (memory).
Push select to delete
KT_SR3000_15_25.p65 05.8.22, 2:07 PM 25