JVC KT-SR3000 - Manual (Page 30)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
30
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Note: Only numbers 1 – 6 can be used for the
access code digits.
1. Upon entering this mode, press the number keys
1 – 6 to enter the current access code (4-digit).
• When you are going to set your access code for
the first time, enter any 4-digit number.
The “New Code” screen appears.
2. Press the number keys 1 – 6 to enter your new
access code (4-digit).
The confirmation screen appears.
3. Press the number keys 1 – 6 to enter your new
access code (4-digit) again.
The access code is now changed.
9 Audio Level Options
You can adjust the audio level and gain at the same
time when you feel that the sound through your JVC
PnP is too soft or too loud.
Upon entering this mode, a horizontal bar graph is
displayed.
Press CAT
3 / 2 (or CAT + / –) to adjust the audio
level and gain, then press SEL (or SELECT).
(You can also use CH
5 / ∞ (or CH + / –) for
adjustment.)
“Lock” appears, next to the channel, on the screen.
To activate locked channels again, repeat the same
procedure and delete “Lock”.
Note: Locked channels can be accessed by
directly entering the channel number and entering
the right access code.
Edit Code
You can set or change the access code as you like.
KT_SR3000_26_35.p65 05.8.22, 2:08 PM 30