JVC KT-SR3000 - Manual (Page 31)

31
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
0 Antenna Aiming
When you use your JVC PnP at home, you have to
adjust the aiming of the SIRIUS antenna to ensure
optimum reception.
Upon entering this mode, two horizontal bar graphs
are displayed.
The current satellite signal strength level is displayed
on the SAT graph, while the current terrestrial signal
strength level is displayed on the TER graph.
Adjust the aiming of the antenna so that the level
indication on the bar graph moves as close to the right
end as possible.
To exit from this option, press MENU or SEL
(or SELECT).
Note: Terrestrial repeaters are typically used in
large urban areas where satellite signal reception
is not stable.
• Terrestrial signals (TER) may not be available in
your residential area.
- Memory Options
You can activate or deactivate the S-Seek function. In
addition, you can delete all stored PDTs (see page 23)
at a time.
The following adjustments are possible on this sub-
menu screen—“Auto Memory Search” and “Clear
All Memory”.
Auto Memory Search: Press CH
5 / ∞ (or CH + / –)
to select either “On” or “Off”, then press SEL (or
SELECT).
• On: To activate the S-Seek function.
• Off: To deactivate the S-Seek function.
Clear All Memory: Press CH
5 / ∞ (or CH + / –) to
select either “Yes” or “No”, then press SEL (or
SELECT).
• Yes: To erase all stored PDTs.
• No: To cancel the erasure.
KT_SR3000_26_35.p65 05.8.22, 2:08 PM 31