JVC SR-VS10U - Manual (Page 69)

EN
69
1 2 3
4 5 6
7 8 9
0
2
4
1
3
T W
DV VHS
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
2
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B (
੬
Step 2),
pressing "1" for A-code commands and "2" for B-code
commands.
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
POWER
NUMBER "1"
STOP
NUMBER "2"
(Ex.) To set remote control B code:
Press in succession
Hold
down
Release 2 STOP
POWER
A/B